canon pro 100 setup

Before we start, there are a few conditions that should be met to use the WPS press button strategy:

The passageway should have an actual WPS press button accessible. Kindly check with your device's user guide for subtleties.

On the off chance that the WPS press button isn't accessible if it's not too much trouble, use the directions on the Standard Connection Method segment.

Your network should use the WPA (Wi-Fi Protected Access) or WPA2 security convention. Most WPS empowered passageways use this convention

Ensure that the printer is turned on. canon pro 100 setup Press and hold the [Wi-Fi ] button on the highest point of the printer until the white force light glimmers once and afterward discharge it.

Ensure that the Wi-Fi button begins to streak blue and afterward go to your passageway and press the [WPS] button inside 2 minutes.

For precise insights about squeezing the WPS button, if it's not too much trouble, allude to the passage manual.

The blue Wi-Fi light on the printer will proceed ?ash while looking for, or associating with the passage. During the setup the white force light will also begin to streak. At the point when the printer has effectively made an association with your wireless network, the blue and white lights will quit blazing and stay lit.

o affirm that your printer is effectively associated with your wireless network, you can print out the network settings of your printer in the event that you wish:

Ensure that your printer is turned on.

Burden a sheet of A4 or Letter-sized plain paper.

Press and hold the [Resume/Cancel ] button until the white force light blazes multiple times, and afterward discharge it. The network data page will be printed.

When alluding to the printout, check that the "Association" designates "Dynamic" and that the SSID - Service Set Identifier (or the name of your wireless network) shows the right name of your wireless network.

This finishes up the WPS setup method. Also check: Download USB Driver