Pay Attention To The Following Three Points When Using Mining Cranes

In some more dangerous areas, such as mines, these ore need to be lifted, so you need to use the corresponding lifting equipment, one of which is very easy to use is the mining crane. Its effect is very good, it can complete the task quickly, but there may be many people who don't know this kind of equipment, let's take a look at Crane factory together.

The use of mining cranes has brought people a lot of convenience. It has shortened people's work cycle to a large extent and improved people's work efficiency. It is a very practical equipment. However, certain procedures must be followed when using it, otherwise some unpredictable accidents may occur, causing harm to people.

1. Walking with load

Try not to walk with load as much as possible, but there are also some that cannot be avoided. At this time, you need to pay attention: the load must be within 70% of the lifting weight, and the distance between the component and the ground must be strictly controlled, and it must face the front position. .

2. Lifting point

When using a mining crane, the lifting point should be above the center of gravity of the object to be lifted, and the two should be on the same vertical line and cannot be lifted diagonally.

3. Running lights

It should also be noted when using the running lights that they are used within the rated voltage range of 36v and cannot be replaced with other voltages.

The above are the points you should pay attention to when using mining cranes. I hope it will help you.

Pay Attention To The Following Three Points When Using Mining Cranes